Pressing Instructions
Follow these step-by-step guides for perfect results with every transfer type we offer.
DTF (Direct to Film)
Step-by-Step Instructions
- Pre-heat your heat press to 300-325°F (150-163°C)
- Place your garment on the heat press and pre-press for 3 seconds to remove moisture
- Position the transfer face down on the garment
- Press firmly at medium pressure for 15 seconds
- Peel the film while still hot (hot peel)
- Cover with parchment paper and press again for 5 seconds to seal
Pro Tips
- Ensure even pressure across the entire transfer
- Do not wash for at least 24 hours after application
- Wash inside out on cold — tumble dry low
UVDTF (UV Direct to Film)
Step-by-Step Instructions
- Clean the surface thoroughly with rubbing alcohol
- Peel the clear backing layer from the transfer
- Position the sticky side down on the hard surface (tumbler, phone case, etc.)
- Use a squeegee or credit card to smooth out any bubbles, working from center to edges
- Slowly peel the top carrier film at a 45-degree angle
- Apply a UV-resistant clear coat for extra durability (optional)
Pro Tips
- Works on hard surfaces: tumblers, mugs, phone cases, laptops
- No heat press needed — cold application only
- Best results on smooth, non-porous surfaces
- Hand wash recommended for tumblers
Sublimation
Step-by-Step Instructions
- Pre-heat your heat press to 385-400°F (196-204°C)
- Place the sublimation paper face down on the polyester garment or sublimation blank
- Secure with heat-resistant tape to prevent shifting
- Press at firm pressure for 45-60 seconds
- Remove the paper while still hot (hot peel)
- Allow the item to cool completely before handling
Pro Tips
- Only works on polyester or poly-coated substrates
- White or light-colored garments only — sublimation ink is transparent
- Use butcher paper under and over the garment to prevent bleed-through
- Colors may appear dull before pressing — they activate with heat